Techno Print specializes in the design and production of custom hot stamp and heat transfer foil decorating machines. We have a broad range of performance oriented hot stamping machines, which are considered for their premium performance and efficiency.
The machine model MH 16P is an easy-going machine for Hot Stamping, it uses a heated roller to apply decorative foil or heat transfer decals to cylindrical and draft angle (taper) surfaces. This machine had wide acceptance in the Paint / Oil / Lubrication Bucket (Pails) decoration printing industries.
This machine is a single mandrel machine and works up to 03 parts per minute*. The product is loaded manually and automatically ejected after the printing cycle. Being a single mandrel machine the set-up time is very less and tooling cost is minimized.
A wide range of part sizes can be accommodated and the starting position of the product can be set precisely as desired.
It has the ability to decorate directly from the moulding process with front-mounted operator interface The machine MH 16P provides brilliant, multi-coloured graphics with "no label" look, where decoration appears to be part of the container
|2||Stamping Temp (Range)||0C||30 - 350|
|4||Printing Dimension (Round)||inch||16"Ø x 12"H|
|5||Printing Dimension (Flat)||inch||NA|
|6||Linear Printing Speed||inch/s||4|
|7||Printing Output**||pcs/min||At Actuals|
|8||Power Requirement||-||230V; 1Ø; 50Hz|
|9||Machine Dimension (L x B x H)||inch||-|
|10||Package Dimension (L x B x H)||inch||-|
The machine is known for the high performance, simple operation and low maintenance.
Overall power consumption is up to 40% less, related to conventional machines.
Precise foil advance system which can be adjusted to enable the operator to locate the foil at the correct position.
Programmable stretch control of foil which Maintains consistent transfer tension for draft angle (taper) articles by use of electro-magnetic particle clutch.
Operator-friendly graphical display for rapid parameter adjustment.
Front panel speedy control to set ideal head travel speeds, stamping pressure, and foil stripping condition.
Convenient and easy stroke length adjustment for rapid setup.
Accurate, repeatable cycling for minimal foil waste.
Optimum Performance and Transfer Quality from job to job.
Special provision are made to avoid damage of silicone roller in case of power failure.
This machine is pneumatically operated and has PLC based control system.
For precise temperature control the machine is equipped with PID temperature controller.
Rugged cast iron frame provides high repeatability, while modular design permits easy adaptation to oversize parts
The machine is rugged yet compact in construction.
State-of-the-Art Technology for product orientation and Hot Stamping Process.
The starting position of the product can be set precisely as desired by use of high end laser sensor.
Non-contact infrared temperature sensor to map the precise temperature over the silicone roller surface.
All machined components are coated for long-term protection.
The vertical movement of the stamping head is guided by precision ground S.S. guide rods and phosphor bronze bushes.
The to and fro movement of the carriage housing of the digit wheel is guided in hardened & precision ground and plated guide rods and linear bearings.
This machine uses German made infrared ceramic heaters, for better Performance and long life.
All major Electronic Control System components are from reputed manufacturers like Omron, Selec, Schneider Electric, Laptron, etc.
All major Pneumatic System components are from reputed manufacturers like Festo, Janatics, etc.
Semi-automatic part loading system
Semi-automatic ejecting system
Image / Dot sensor for foil
Vacuum Pump for holding the product
Auto Blow Ejecting System